Good afternoon Rick
*This reply is strictly referring to the case where I need to use the z table values in a condition step; the question is the same: how to pick up the z table values in the condition (container vs attribute)
- By container I am referring to the "technical" workflow container which
can be used to hold different values . I was thinking this container could be filled by using a bapi/macro/zprogram and then used in the condition step.
- By attribute I am referring strictly to the object attribute as seen in swo1. (so a new attribute would be created with the value of the z table and then used in the condition step)
Rick you mentioned a method container, were you thinking about reading the z
table via a method in a separate step and then passing the values to the condition
step?
*All the information received on this post is very useful.
*Regarding this scenario I also understood from Karri's reply that making an attribute wouldn't be that hard but the workflow log could suffer.
Thank you for your patience.
Best regards
Razvan Zainea